Meade-instruments TE923W-M Bedienungsanleitung PDF herunterladen (Seite 33)

Setting up the Daily Rainfall Alert

• In the Rain Mode, press ALARM/CHART to display the rainfall alert.

• Press and hold ALARM/CHART until the rainfall alert “ALARM HI” will flash.

• Set the desired value for the Rainfall Alert by using UP or DOWN. Press and hold either button

for fast digits advance.

• Press ALARM/CHART to confirm selection and the unit will return to the rainfall alert display.

Disabling the Daily Rainfall Alert

In the Daily Rainfall Alert Mode press the ALARM/CHART button to disable the alert.

Wind Mode

The wind direction is shown by an animated compass display. Its angle can be displayed as

compass points (i.e. NW) or in bearings starting from north (i.e. 22.5º).

The upper left section of the wind mode can be programmed to display either a temperature at the

place of anemometer or the temperature adjusted to the wind chill factor.

The lower left section of the wind mode indicates the average wind speed for the past 10 minutes,

as well as gust, wind speed alert and gust alert information. It can also show records of the

maximum wind speed and wind gust collected during the day.

The wind speed and gust alert functions can be programmed to alert you if the wind speed or gust

exceeds a pre-configured limit. The wind speed can be displayed in km/h, mph, m/s or knots.

Note: The wind speed alert has a 5 mph deviation and the wind gust speed alert has a 7 mph

deviation. It is set to prevent the alerts from sounding all the time due to small fluctuations close

to the alert value. This means that after the wind speed reaches the alert value, it will have to fall

below the alert value plus deviation to activate the alert.

Accessing Wind Mode

Press main unit UP or DOWN until the WIND icon on the display starts flashing.

From the remote control: Press .

Configuring Wind Display

In the Wind Mode, press the SET button to recall either a wind chill temperature with wind

direction in bearings, a wind chill temperature with a wind direction in compass points, a

temperature at anemometer and wind direction in compass points or a temperature at anemometer

and wind direction in bearings.

Setting Units for the Wind Speed in km/h, mph, m/s or knots

In the Wind Mode, press and hold the SET button to set the wind speed units in km/h, mph, m/s

or knots.

Viewing Wind Statistics

In the Wind Mode, press the MEMORY button to recall a current wind speed, a daily maximum

wind speed with “DAILY MAX” displayed, a gust speed with a “GUST” displayed and a daily

maximum gust speed with a “GUST DAILY MAX” displayed.

Resetting the Wind Statistics Memory

In the Wind Mode, press and hold MEMORY to reset all wind statistics.

MP 82:5 ,80/11/4dmp.R LLEWYENOH )GNE(1MI W329ET 33

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 43 44

Keine Kommentare

Meade-instruments TE923W-M Bedienungsanleitung Seite 33